Configure a Location for the Azure Virtual Desktop Metadata – Design the Azure Virtual Desktop Architecture

Configure a Location for the Azure Virtual Desktop Metadata

Azure Virtual Desktop can be used as a worldwide service depending on your location and the location of the VMs. The control plane is available in the following locations (as of September 2021); however, the host pool can exist in any other Azure region:

•\   United States (US) (generally available)

•\   Europe (EU) (generally available)

•\   United Kingdom (UK) (generally available)

•\   Canada (CA) (generally available)

Just remember that your performance using a host pool outside of the previous locations might vary until the control plane is added to other regions because all Azure Virtual Desktop client traffic goes through the control plane (if not using shortpath).

If you set up a host pool in a non-metadata location with a previous control plane location, you will automatically switch to the local control plane when it’s rolled out for your region.

If RDP shortpath is enabled, then RDP shortpath establishes the direct connectivity between the Remote Desktop client and the session host. Direct connectivity reduces the dependency on the Azure Virtual Desktop gateways, improves the connection’s reliability, and increases the bandwidth available for each user session

Calculate a Configuration for Performance Requirements

Azure Virtual Desktop performance is dependent on multiple factors such as the application, user Internet connection, user location and host pool region, Azure Virtual Desktop management service location, network bandwidth to on-premises if the application/AD/ANS is on-premises, and the application. All of these aspects need to be considered while designing the Azure Virtual Desktop architecture.

The following are the recommendations for optimal performance:

•\ The appropriate VM size needs to be selected (based on assessment) for Azure Virtual Desktop.

•\ If there are application servers in the on-premises datacenter that need to be accessed from Azure Virtual Desktop, then the application bandwidth recommendation needs to be followed.

•\ If there are custom/third-party applications that need to be installed on Azure Virtual Desktop, then the application sizing recommendation needs to be followed.

•\ Round-trip (RTT) latency from the client’s laptop to the Azure region (where host pools have been deployed) should be less than 150 ms. Use the Experience Estimator to view your connection health and recommended Azure region.

•\ To optimize for network performance, Microsoft recommends that the session host’s VMs are collocated in the same Azure region as the Azure Virtual Desktop management service.

Make sure to load test these scenarios in your deployment using simulation tools like Login VSI. Vary the load size, run stress tests, and test common user scenarios in remote sessions to better understand your network’s requirements before moving into production.

Leave a Reply

Your email address will not be published. Required fields are marked *